✔➸ MMDVM hotspot supports D-STAR DMR YSF P25 NXDN POCSAG, enables the different mode of digital two way radio to communicate with each other (YSF2DMR / YSF2NXDN / YSF2P25 / DMR2YSF / DMR2NXDN) and works great with UHF. If there are changes, please refer to https://forum.pistar.uk/
    ✔➸ Added external inductor. Support VHF communication, the effect cannot reach the perfect effect of UHF
    ✔➸ MMDVM hotspot is a fully-assembled device.
    ✔➸ HOTSPOT comes pre-configured for a Wi-Fi network. SSID: Pi-Star (or Pi-Star-Setup) Password: raspberry, Just connect to temporarily WIFI: pi-star then you can access the device through your web browser using Pi-Star. And then save your own house WIFI details to HOTSPOT according to the step 2 of the instruction manual.
    ✔➸ HOTSPOT size: 2.8 x 1.3 x 0.9” inch.

Product description


Not compatible with Baofeng UV-5R, Baofeng RD-5R, 5X, 5R+, 5R Plus, etc UV series, BF series

Need to know before buying, thank you so much.

1. Please place HOTSPOT within 5 meters from WIFI, please be careful not to be blocked by the wall, otherwise IP unknown will appear, because ZERO W does not have WIFI receiving antenna, WIFI receiving ability is worse than mobile phone or computer.
2. We will send the HOTSPOT to you after test call at 439.550.000MHz frequency, so we save the call sign and other information of BD7OAY. After you receive the unit, set HOTSPOT to connect to your house WIFI and set your RADIO RX / TX frequency to 439.55MHz, RX and TX should be set to the same frequency because the HOTSPOT is simplex.
3. Hotspot does not support 5.8G, only 2.4G. If your cell phone supports 5.8GWIFI, please turn off 5.8G, so that Verizon mobile can provide 2.4G signal to HOTSPOT (E.g. The S9+ supports a 5Ghz hotspot and 5 GHz (only) enabled by default). 4. The shell is made of aluminum, and there may be defects in the manufacturing process (For example, local uneven paint).
5. The engraving characters are placed by hand on the engraving machine. The engraving position may be up or down.

If you mind the above, please buy with caution.


Basic Setup:

After power on 2 minutes，use computer to connect to temporarily WIFI: pi-star (or Pi-Star-Setup) then you can access the device through your web browser go to http://pi-star.local/admin/configure.php
Login username is pi-star
Password is raspberry
And then save your own house WIFI details to HOTSPOT according to the step 2 of the instruction manual.

Package content:

1 x MMDVM hotspot (one fully-assembled device host include: one MMDVM hotspot board with OLED display, one Raspberry Pi Zero W, one 8G TF card, one Aluminum Shell) 1 x UHF / VHF telescoping antennas.

Not include cable.